contact
CAT-601S is a high-tech intelligent product. Before changing the oil, the equipment samples the old oil and detects whether the old oil is damaged and needs to be replaced by means of odor recognition.
Item |
Description |
√ |
Old oil sampling |
Sampling the oil from AT |
√ |
Add detergent |
Add ATF detergent to AT |
√ |
Exchange |
Exchanging ATF |
√ |
Adjust fluid level |
Adjusting the quantity of fluid inside AT |
√ |
Empty new tank |
Draining left fluid inside new fluid tank |
√ |
Empty used tank |
Draining used fluid inside used fluid tank |
√ |
System setting |
Calibration of electronic, scale, adjusting contrast, language selection, and database entry. |
√ |
Power supply
|
AC110V/AC200V 50Hz/60Hz
|
Pump power
|
150W
|
Working temperature
|
-10~50℃
|
Relative humidity
|
<90%
|
Working noise
|
<70db
|
Working air pressure
|
86~106kpa
|
Waterproof and dustproof
|
Ip42
|
Filter accuracy
|
5μm
|
Rate of flow
|
≥2.2L/60s
|
Oil tank
|
20L×2
|
Equal exchange error
|
±100mli
|
Pay attention to each connection to check if there is any leakage during fluid exchange. When any leak is found, stop the CAT-601S immediately and check for the unit. Start to exchange fluid again after reconnection is made.
Before cleaning up the unit, the used fluid should be drained out from the used fluid tank and the new fluid should be drained out from the new tank and stored in the container after every usage to protect the electronic scale on the no-load state at non-work conditions.
Keep the new fluid tank clean.
Please recalibrate the electronic scale after replacing the main-board and/or the electronic scale itself.